How do you disable promiscuous mode?

Question

_{Thursday, December 27, 2018 7:37 PM}

Zillon's of articles about how to enable promiscuous mode, but I cannot find a single thing about disabling when you don't want it. Any help? Maybe a really easy powershell command to do it on "ethernet0"?

All replies (3)

_{Thursday, December 27, 2018 10:06 PM}

Hi Joel,

To Disable Promiscuous Mode please use this cmd

To disable promiscuous mode on the physical NIC, run the following command on the XenServer text console:

# ifconfig eth0 –promisc

Run the ifconfig command again and notice that promiscuous mode is now disabled.

On the either net interface

user@host# delete interfaces interface-name promiscuous-mode

Hope this helps

_{Friday, December 28, 2018 1:45 AM}

Hi,

Please refer to the link below:

https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/interface-security-ethernet-promiscuous-mode-enabling-and-disabling.html  

Please Note: Since the web site is not hosted by Microsoft, the link may change without notice. Microsoft does not guarantee the accuracy of this information. 

Best regards,

Travis

Please remember to mark the replies as an answers if they help.
If you have feedback for TechNet Subscriber Support, contact [email protected]

_{Tuesday, January 1, 2019 9:09 AM}

Hi,

Just checking in to see if the information provided was helpful.

Please let us know if you would like further assistance.

Best Regards,

Travis

Please remember to mark the replies as an answers if they help.
If you have feedback for TechNet Subscriber Support, contact [email protected]