Note
Access to this page requires authorization. You can try signing in or changing directories.
Access to this page requires authorization. You can try changing directories.
Question
Thursday, June 19, 2008 4:15 AM
How do I add a newly added network adapter to the cluster?
I have added a dual port nic to the nodes of a cluster and named them the same. How do I get them to show up in the Failover Cluster Management Networks? I have rebooted each node twice.
Thank you.
All replies (2)
Thursday, June 19, 2008 2:52 PM âś…Answered
Configuration of the network supported by the new NIC must be seen as separate from networks cluster already knows about. Run validation and select only the Network tests and see what the results are.
Chuck
Thursday, June 19, 2008 6:46 PM
It appears that you must provide an IP Address to the NIC on all nodes before it will be visible in Failover Cluster Management.